User Manual

SETTINGS Setup menu En 66
SETTINGS
A variety of settings for this unit can be specified and adjusted from the setup menu. Among the options available are the sound beam output
method for optimal surround sound effects, channel volume control, and HDMI settings.
The setup menu is displayed on, and operated from, the TV screen (it cannot be displayed in the front panel display). See “Displaying the
menu screen on the TV” (p. 27) for instructions on displaying the setup menu on the TV.
Setting the setup menu
1
Press the SETUP ( ) key.
The menu changes as follows each time the SETUP ( )
key is pressed.
Hold down the SETUP ( ) key to display “OSD Language” directly on the
screen (p. 28, 77).
If an update for the unit’s firmware is available, an envelope icon ( ) will be
displayed in the setup menu (p. 87).
2
Press the S/T key to select a menu and then press
the ENTER key or X key.
Repeat these steps to display the desired menu.
Press the W key or RETURN ( ) key to return to the
previous menu.
3
Press the S/T key to change the setting value of
each menu.
4
Press the SETUP ( ) key again to exit the setup
menu.
Setup menu
T
Configure “Beam”, “Sound”, “HDMI”, “Display”, and
“Information”.
T
Configure “Network” and “Bluetooth”.
T
Exit the setup menu.
Setup Menu
Beam
Sound
HDMI
Display
Information
IntelliBeam
Horizontal Angle
Vertical Angle
Beam Travel Length
Focal Length
Image Location
Channel Out
Subwoofer
Setup Menu
Beam
Sound
HDMI
Display
Information
IntelliBeam
Horizontal Angle
Vertical Angle
Beam Travel Length
Focal Length
Image Location
Channel Out
Subwoofer
///
ENTER
SETUP ( )
RETURN ( )