User Manual

Troubleshooting
MX49/MX61 Remote Editor Owner’s Manual
15
On the DAW software other than Cubase, the set parameters are not controlled.
• The Remote control functions are available only for Cubase. Set the Remote/CC buttons (page 8) to
“CC.”
• Make sure that the “DAW select” parameter is set to something other than “Cubase” by pressing
[UTILITY]  Select “04:Remote”  [ENTER].
Even when I select another track on the DAW software, the VSTi to be controlled does
not change; instead, the VSTi which is assigned to the previously selected track
remains under control.
• When using Cubase, select “Yamaha MX49/MX61” in the Remote Device Setup window, then select
Port 2 for the MX49/MX61 as the MIDI Input/Output.
• Make sure to set the MX49/MX61 instrument to the Remote mode (page 5).
U.R.G., Digital Musical Instruments Division
© 2012 Yamaha Corporation
209MW-A0