User Manual

YC-3B window: Effect window
YC-3B Owner’s Manual
4
Effect window
1 Preset
2 [Voice] button/[Effect] button
3 Master Volume knob
These are same as in the Voice window.
4 Distortion
Sets the Distortion effect. The button at the top will turn on/off this effect.
5 Rotary
Sets the Rotary Speaker effect. The button at the left top will turn this effect on/off.
Volume knob
Adjusts the output level of the Distortion.
Drive knob
Adjusts the amount of Distortion. Turning this knob to the right will increase
the Distortion amount, and vice versa.
Treble knob
Adjusts the Treble gain of the Distortion.
Bass knob
Adjusts the Bass gain of the Distortion.
Slow/Fast switch
Stop/Run switch
These switches are the same as in the Voice window. See page 2.
Mic Angle knob
Adjusts the angle of the virtual microphones at both the right and left sides of
the speaker.
Turning this knob to the right will increase the angle, meaning that the output
sound moves widely between left and right.
R/H Balance knob
Adjusts the volume balance between the rotor section (bass) and the horn
section (treble) of the rotary speaker.
Setting this knob to the center will make both the levels equal. Turning this
knob to the right will increase the horn level and decrease the rotor level, and
vice versa. Turning this knob all the way right will produce only the horn
sound, while turning it all the way to the left will produce only the rotor sound.
1
4
6
5
2
3