User Manual

MX49/MX61 Reference Manual
Basic Structure
Using a Connected
Computer
Using iOS
Applications
Basic Structure
Controller Block
Tone Generator Block
Effect Block
Arpeggio Block
Song/Pattern
Playing Block
Internal Memory
MIDI/Audio Signal Flow
Connecting to a computer
Creating a Song with a
computer
Reference
Performance
Song/Pattern
File
Utility
Remote
32
Setting up the DAW software on the computer
Start the DAW software on the connected computer. Then, follow the setup instructions below.
NOTE When the cable connecting the MX49/MX61 to the computer is disconnected or the MX49/MX61 is turned off accidentally, the
DAW will not recognize the MX49/MX61 again. If this occurs, exit the DAW software, then restart it after setting up the MX49/
MX61 and making sure the connection is secure.
NOTE For details on DAW software versions that are compatible with the MX49/MX61, see the “Specifications” of the “Owner’s Manual”
PDF document.
NOTE Not all of the following functions may be available, depending on your particular software version or your computer environment.
 Cubase
Install MX49/MX61 Remote Tools to complete the setup.
 SONAR
1 Pull down the [Edit]  [Preferences] menu and select [Devices] of “MIDI.”
2 Add “Yamaha MX49/MX61-2” to the Input Device, then add “Yamaha MX49/MX61-2” to the Output Device.
3 Pull down the [Edit]  [Preferences] menu and select [Control Surfaces].
4 Click the [+] button, select “Mackie Control,” then set the Input Port to “Yamaha MX49/MX61-2” and set the Output
Port to “Yamaha MX49/MX61-2.”
 Digital Performer
1 In the Audio/MIDI setup of a Mac computer, connect Port 2 of the interface of the MX49/MX61 to Port 2 of the tone
generator. When there is only one Port for the tone generator, add the new Port, then connect it to the interface.
2 Pull down the [Setup] menu and select [Control Surface Setup] to call up the Control Surface window.
3 Click the [+] button.
4 Select “Mackie Control” in the Driver section.
5 In the box for setting “Unit” and “MIDI,” select “Mackie Control” in the “Unit” section and select “MX49/MX61 New
Port 2” in the “MIDI” section.
 Logic Pro
1 Select the [Preferences] menu  [Control Surfaces Setup] to call up the Setup window.
2 Select the [New] menu  [Install].
3 Select “Mackie Control” in the model list, then add it as a control surface.
4 Set the MIDI Output Port to “Yamaha MX49/MX61 Port2.”
NOTE Mackie Control is the trademark of Mackie Designs, Inc.