User Manual
高级设定
DME 设定说明书 16
zzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzzz
电脑网络设定
必须设定电脑的 IP 地址和 TCP/IP 筛选以启用与 DME 设备的网络通信。
Windows Vista / Windows 7
1
选择
[Start]
[Control Panel]
,然后单击
或
双击 [Network and Sharing Center] 或
[View network status and tasks]。
将显示 “Network and Sharing Center”。
2 单击“Network and Sharing Center”窗口
左侧的 “Tasks”列表中的 [Manage
network connection] 或 [Change Adapter
settings],然后双击 [Local Area
Connection]。
将显示 “Local Area Connection Status”对话
框。
可能会出现 “User Account Control”对话框。单击
[Continue] 或 [Yes] 按钮。
如果出现 “
Local Area Connection properties
”对话
框,请跳到步骤
4
。
3 单击 [Properties]。
将显示 “Local Area Connection properties”对
话框。
可能会出现 “User Account Control”对话框。单击
[Continue] 或 [Yes] 按钮。
4 在 [Network] 选项卡中,选择 [Internet
Protocol Version 4 (TCP/IPv4)], 然后单击
[Properties] 按钮。
将显示 “Internet Protocol Version 4 (TCP/IPv4)
Properties”对话框。
5 单击 [General] 选项卡上的 [Use the
Following IP Address]。
6
在
[IP address]
中输入电脑的
IP
地址,在
[Default gateway]
中输入网关的
IP
地址,然后
在
[Subnet mask]
中输入“
255.255.255.0
”。
必须将网络地址设定为与DME设备相同的地址,而必
须将主机地址设定为另一个数值。
有网关时,设定网关的 IP 地址。没有网关时,设定空
的地址。应将地址设定为与 IP 地址相同的子网。在设
定了子网的LAN 中,也应将地址设定为与IP 地址相同
的子网。
7 单击 [OK]。
Windows XP
1 选择 [Start] [Control Panel]。
显示 “Control Panel”。
2 如果控制面板采用分类视图,请单击 [切换到
经典视图 ]。
3 双击 [ 网络连接 ] [ 本地连接 ]。
将显示 “本地连接状态”对话框。
如果出现 “本地连接属性”对话框,请跳到步骤 5。