User Manual

MY8-LAKE Owner’s Manual 21
This stores all module information
(levels, x-over and EQ settings) from
the selected module as a new module
file for future recall. You can recall the
file and overwrite a different module.
4. Tap the [Home] button, then tap
the [System Store/Recall] button.
5. Tap the [Store System] button,
then enter a system name, and
finally tap [OK] (or press
<Enter>).
This stores all data (frame and module
data) in your current system before
proceeding to change the device
configuration. Input and output routing
settings as well as input mixer settings
are part of frame data. We recommend
you get into a habit of regularly saving
your work to minimize the risk of data
loss.
NOTE
For further information about storing of
Module files, Base Configuration files,
System and Sub-System files, refer to the
Lake Controller Operation Manual.
Changing the MY8-LAKE
Frame Configuration
To review the functionality of the MY8-LAKE
card in loudspeaker processor (Contour)
mode, the MY8-LAKE Frame configuration
must be changed from the default Mesa
mode to Contour mode.
1. Tap the [Home] button, then tap
the [Modules] button.
2. Make sure that a module is
selected, then tap the [I/O
Config] button, and finally the
[Frame Config] button.
3. Tap the [Contour Reset] button,
then tap [Yes] after reading the
important warning dialog.
The screen changes to show the
module scroll bar and the reconfigured
modules will appear on the scroll bar
after a few seconds. The Frame can be
configured using any of the three
available reset options shown above
as required.
4. Select one of the MY8-LAKE
Contour modules from the
module scroll bar and place it in
the main work area.
The default 4 x Classic 2-Way
Crossover modules appear as shown
below.