Owner`s manual

MY8-SDI-ED Owner’s Manual 7
If no errors have occurred, the LED indicators will light green. If an error has
occurred, you will be able to identify the type of error based on the status of the
LED indicators as shown in the list below.
Note:
If multiple errors have occurred simultaneously, the priority of the SDI STATUS LEDs
indication is the descending order of the list above.
5 GROUP SELECT Switches
Selects a group of audio input/output signals.
Move the switches down to set them to ON. Raise the switches to set them to
OFF.
Note:
Do not change the switch settings if the host device is powered on. Otherwise, noise may
be generated.
•[IN 1–4]
These switches enable you to turn ON up to two SDI signal groups that you
want to input to the slot (host device). Audio signals can be de-embedded from
a selected group and routed to input ports 1–4 and 5–8 of the slot.
• [OUT 1–4]
These switches enable you to turn ON up to two SDI signal groups that you
want to output from the slot (host device). Signals at output ports 1–4 and 5–8
of the slot can be embedded and routed to a selected group.
LED Indicator SDI STATUS LED Description of Error
Off (dark)
[IN]/[OUT] No SDI input is detected or routed.
[A1
–4]/[A5–8]
No audio group has been selected.
Solid red [IN]/[OUT] SDI input or output is unlocked.
Flashing red
[IN]
An invalid format signal is being input to
the SDI input.
[A1
–4]/[A5–8]
No selected audio group data exists.
Solid orange
[IN]/[OUT]
An error has occurred in the video signal of
the SDI input/output.
[A1
–4]/[A5–8]
An error has occurred in the selected audio
group data.