English mLAN Interface Card Français Español Owner’s manual Bedienungsanleitung Mode d’emploi Manual de instrucciones Deutsch MY8-mLAN
MY8-(E).book Page 2 Thursday, October 11, 2001 10:05 AM WARNING Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, short-circuiting, damages, fire or other hazards. These precautions include, but are not limited to, the following: • Do not attempt to disassemble or modify the card. Do not apply excessive force to card connectors or other card components.
MY8-(E).book Page 3 Thursday, October 11, 2001 10:05 AM Thank you for purchasing the Yamaha MY8-mLAN. The MY8-mLAN is an interface card that provides mLAN interfacing. mLAN is a digital network designed for music and based on the IEEE 1394 high performance serial bus. mLAN makes it easy to construct sophisticated networks for audio and MIDI signals that can be re-configured without changing the physical cabling (as was necessary with previous systems).
MY8-(E).book Page 4 Thursday, October 11, 2001 10:05 AM Table of Contents Introduction ................................................................................... 3 English Package Contents........................................................................... 3 How to install the MY8-mLAN ....................................................... 5 Names and Functions..................................................................... 6 DIP switch (SW1) settings................................
MY8-(E).book Page 5 Thursday, October 11, 2001 10:05 AM How to install the MY8-mLAN 1. Set the MY8-mLAN’s DIP switch (SW1) according to your application. For details refer to page NOTE It is not possible to change the setting of the DIP switch (SW1) after the MY8-mLAN is installed. You must set the DIP switch before installation. If you want to change the settings, you must turn off the host device, remove the MY8-mLAN, and then change the settings. 2. Install the MY8-mLAN into your device.
MY8-(E).book Page 6 Thursday, October 11, 2001 10:05 AM Names and Functions English 1 2 3 A mLAN (IEEE1394) jacks These jacks are used to connect mLAN devices or IEEE1394-compatible devices via IEEE1394 standard (6-pin) cables. Each jack has an LED in the upper left corner to indicate the following statuses. green : The MY8-mLAN or connected device is a “leaf” node. off : Not connected. red : When there is a possibility that the sound will be interrupted.
MY8-(E).book Page 7 Thursday, October 11, 2001 10:05 AM DIP switch (SW1) settings English The MY8-mLAN has a switch that specifies whether audio input/output and MIDI input/output via mLAN will be enabled. In this switch, moving the white slider toward the number will turn the setting “OFF,” and moving it toward the side marked ON will turn the setting “ON.” The following settings are assigned to each number 1–8.
English MY8-(E).
