User Manual

2.1. MY16-CII Serial Control and Latency Settings
Figure 17: Yamaha Device Settings Window
Roll your cursor over the Rx or Tx field to see an edit box that allows you to select a serial
channel to be used for reception or transmission. Use the up and down arrow buttons on the right
side of the edit box to select the desired channel. The available range is OFF or 1-15. Data
transfer becomes possible when the channels of the transmitting and receiving devices are
matched. No transmission or reception takes place when OFF is selected.
Hint: As an example, serial control is used for remotely controlling a DME64N from the PM5D.
Figure 18: Rx/Tx Serial channel edit box
Click on the “Bit Length” field to change the audio bit length to be transferred via the CobraNet
network. A popup menu will appear allowing you to select “Bit Off”, “16bit”, “20bit”, or “24bit”.
Figure 19: Bit Length popup menu
CobraNet Manager Lite for Yamaha Owner’s Manual 17