Owner`s manual

38 En
Configuring various functions (Setup menu)
■ Network Name
Edits the network name (the unit’s name on the network)
displayed on other network devices.
1 Select “Network Name”.
2 Press ENTER to enter the name edit display.
3 Use the cursor keys (D / E) to move the edit
position and the cursor keys (B / C) to select
a character.
4 To confirm the new name, press ENTER.
5 To exit from the menu, press SETUP.
■ Update
Updates the firmware via the network.
Adjusting the high and low frequency response.
Adjusting the sound output balance of the left and right
speakers to compensate for sound imbalance caused by
speaker locations or listening room conditions.
Control range
L+10 to R+10
y
For details, refer to the “Adjusting the speaker balance” (p.16).
Sets the maximum volume to prevent excessive loudness.
Setting range
1 to 99 (1 step increments), Max
Default
Max
Sets the initial volume when the receiver is turned on.
Setting range
Off, Mute, 1 to 99 (1 step increments), Max
Default
Off
Configures the DC OUT jack setting.
PowerMode
Selects how to supply power to the Yamaha AV accessory
connected to the DC OUT jack.
Perform
Update
Starts the process to update the unit’s firmware.
For details, see “Updating the unit’s firmware via
the network” (p.40).
Version
Displays the version of the firmware installed on
the unit.
ID Displays the system ID number.
SP A
¡ Network Name
Network
SP A
R-N301 XXXXX
Network
Network name
SPA
R-N301 XXXXX›
Network
Tone Control
Bass
When you feel there is not enough bass (low
frequency sound).
Control range: –10 to +10 (20 Hz)
Treble
When you feel there is not enough treble (high
frequency sound).
Control range: –10 to +10 (20 kHz)
Balance
Max Volume
Initial Volume
DC OUT
Con
(default)
Supplies power through the DC OUT jack
continuously regardless of the power state (on/
standby) of the unit.
Sync
Supplies power through the DC OUT jack only
when the unit is turned on.