User's Manual

45N12 GENERAL SET-UP INSTRUCTIONS Page 9/25
LF +
LF -
HF +
HF -
LF +
LF -
HF + HF -
IMPORTANT
45N12 are factory configured in active mode
2.1.2 Configuring 45N12 for Passive or Active Mode
In order to change active or passive configuration:
- remove the TORX screws that hold the rear/bottom metal panel;
- remove the rear/bottom metal panel to access passive network WAGO connectors.
In Passive Mode, WAGO connector should be inserted in “Passive In”, and speakers WAGO
connectors should be inserted in connector “Passive Out”.
In Active Mode, WAGO Connector should be directly connected to speakers via speakers WAGO
connectors (passive filter is then bypassed).
PASSIVE MODE CONFIGURATION
ACTIVE MODE CONFIGURATION