User manual

NXWIN4 SOFTWARE FOR NXAMP FIRMWARE UPGRADE
Then choose the serial port connected to the NXAMP Powered TDcontroller (note: only the
detected and available serial ports appear in the list), and finally press the download
button. The following splash window should pop up on screen:
To upgrade the NXAMP (fitted with NXES104 or NXDT104 board) through the network,
choose the network port interface and select the network card connected to the NXAMP(s).
Select device that you want to upgrade (by default only units in “Download mode” will be
selected).
Begin the upgrade
You can now confirm the download in the splash screen. The Nxwin4 will detect the
connected NXAMP target, and then download the appropriate software. If a NXES104 or
NXDT104 is fitted and need to be upgraded, it will be automatically done as well.
WARNING! After the upgrade of the NXES104 or the NXDT104 card you will be
prompt to turn the NXAMP powered TDcontroller OFF and ON again in download mode
before proceeding to NXAMP firmware part update.
PAGE 123 OF 140