User manual

NXES104 EXPANSION BOARD, REMOTE CONTROL AND ASIO DRIVER
Select the group you wish to put the NXAMP in. You can group NXAMP4x1 and NXAMP4x4
into the same group. One NXAMP can be part of several groups (for example you can do a
group with all units, and some smaller ones for specific applications).
The remote control page of the group can be accessed if you press the “Group” tab in the
left view of ESmonitor™. If you select a non empty group, you will be able to access the
remote control page of the group, like shown bellow:
Note that only some settings are accessible to the user, if then the user interface is the
same than for an individual NXAMP. On top of the output meters you can choose the
NXAMP of the group you wish to monitor the output meters.
If some settings are different between two units inside the same group, the corresponding
control will be displayed in RED. Once a control is changed in the group control page, the
settings will be applied to all units in the group.
(7) Channels name
This section shows the speaker selected for each channel, together with the chosen
crossover.
Clicking any of these names allows the user to select a new family, speaker, mode or
crossover for each output, thus building a custom setup. Note that some cabinets required
that two channels are linked (cardio speakers for example), thus the next channel will be
automatically recalled.
PAGE 87 OF 140