User manual

NXES104 EXPANSION BOARD, REMOTE CONTROL AND ASIO DRIVER
In Network audio device select the target NXAMP. This NXAMP should be connected to the
LAN through its Remote ES100 port and should be in ASIO mode “To NXAMP” or “To
NXAMP+ES”.
Select the number of Inputs/Outputs with the I/O count setting. For NXAMP, this setting is
either 2/2 (meaning 2 channels of audio out from the computer to the NXAMP) or 4/4
(meaning 4 channels of audio out from the computer to the NXAMP). A bigger number of
channels mean more bandwidth used on the network and more ressources used on the
computer, so if 2 channels are enough (for stereo track playback for example) we
recommend using this setting.
The Status light should be green in the AVS-AsioControlPanel if the NXAMP is ready to
receive audio. It will blink if any ASIO host is currently streaming audio to the NXAMP.
Setting up the ASIO host
Select ‘Auvitran ASIO’ in the ASIO host output device menu. Most of the time the ASIO
host will allow to patch the output of the software to the device input channels.
WARNING! The NXAMP supports only a sampling rate of 48 KHz. Thus the ASIO
host should send data only at this sampling rate or the stream will be refused by the ASIO
streamer. Use eventually a software resampler on the audio host to convert the source
sample rate to 48 KHz.
PAGE 96 OF 140