Installation manual

4
Rotate the jog dial to select “UPDATE · · · · USB”.
5
Press SOURCE.
The firmware update starts. Do not turn off the power to the unit during the update.
6
When “UPDATE SUCCESS” appears on the display, press z (power)
to turn off the power to the unit.
7
Remove the USB storage device from the USB jack.
The firmware update is complete.
NOTE
•Wait about five seconds after the firmware update is complete, and then turn on the power to
the unit.
Viewing the firmware version
You can view the firmware version after the update is complete.
Turn on the power to the unit, and then press SETUP on the remote control. Use the
cursor keys (///) to select “Network”, “Update (Network Update)”, and then
“Version” to display the current firmware version.
In case of an error
If an error message appears on the display during the update operation, the firmware
will not be updated correctly. Determine the cause, and try to update the firmware
again.
Cause Solution
The USB storage device may not be
properly connected to the USB jack.
Make sure that the USB storage device is connected
properly. Then try to update the firmware again.
The firmware data file may not have been
stored in the USB storage device
properly.
Make sure that the file has been stored in the folder on
the highest hierarchy (root folder) of the USB storage
device.
The USB storage device may be
protected by a password or other
methods.
Use a USB storage device that is not protected by a
password or other method.