Owner's Manual

4 En
■ Connections
Before making connection, make sure that the
amplifier is switched off.
• Connect the screw-type terminals at the rear of the
speakers to the speaker terminals on the amplifier with
a supplied speaker cable.
• Connect the + terminals on the amplifier and on the
speakers using one side of the cable. Connect the –
terminals on both components using the other side of
the cable.
• Connect one speaker to the left (L) terminals of your
amplifier, and another speaker to the right (R) terminals,
making sure not to reverse the polarity (+, –). If one
speaker is connected with reversed polarity, the sound
will be unnatural and lack bass.
How to connect
1 Loosen the knob.
2 Twist the exposed wires of the cable together.
3 Insert the bare wire into the hole.
4 Tighten the knob and secure the cable.
Test the firmness of the connection by pulling the
cable lightly at the terminal.
• Do not let the bare speaker wires touch each other as
this could damage the speaker and/or the amplifier.
• Do not insert the insulation coating into the hole.
The sound may not be produced.
CONNECTING TO YOUR AMPLIFIER
Good
No Good
10 mm
Notes
SPEAKERS
A
B
L
R
+
+
–
–
Loosen
Insulation coating
Bare wire
NS-9900 (R) NS-9900 (L)
Amplifier
Speaker
terminals of
the amplifier
Red (+)
Black (–)
Terminal hole
Tighten
1
When using a banana plug (China model only)
1 Unscrew the terminal knob.
2 Remove the cap by pulling it toward you.
3 Tighten the terminal knob.
4 Simply insert the banana plug into the terminal.
2
3
4
Banana plug
Terminal