TG NS-B700 Speaker Enceinte OWNER’S MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG MANUAL DE INSTRUCCIONES
Thank you for selecting this YAMAHA product. PRECAUTIONS Read this before using the speaker. • To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. • Install the speaker in a cool, dry, clean place - away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of electrical noise (transformers, motors). To prevent fire or electrical shock, do not expose this unit to rain or water.
■To mount the speaker on a wall by using the attached mounting bracket PLACING THE SPEAKERS ■Using as 2ch stereo speakers Better stereo images will be obtained when the speakers are slightly angled in towards the listeners. Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting bracket on the protruding screws.
CONNECTIONS TO YOUR AMPLIFIER ■How to connect 1 2 Before making connections, make sure that the amplifier is switched off. Loosen the knob. Remove 10 mm (3/8”) of insulation from each end of the cables, and twist the exposed conductors together neatly and tightly, as shown below. 10 mm (3/8 ”) Loosen Tighten Good Red (+) Black (–) 3 4 Bare wire Insulation coating No Good Insert the bare wire. Tighten the knob and secure the cables.
ATTACHING THE FRONT COVER The speaker and the front cover are packed separately. To attach the front cover, line up the projections (magnets) on the reverse side of the front cover with their corresponding screw heads on the speaker. Notes • When removing the cover, be careful that you don’t touch the drive units, and don’t exert excessive force with any tools. • There are magnets on the reverse side of the front cover.
©2008 Yamaha Corporation All rights reserved.