UTG NS-B310 NS-C310 Speaker Enceinte OWNER’S MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG MANUAL DE INSTRUCCIONES
Thank you for selecting this YAMAHA product. PRECAUTIONS Read this before using the speaker. • To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. • Install the speaker in a cool, dry, clean place - away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of electrical noise (transformers, motors). To prevent fire or electrical shock, do not expose this unit to rain or water.
SUPPLIED ACCESSORIES (Only for NS-C310) ■To mount the speakers on a wall by using the attached mounting bracket Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting bracket on the protruding screws. * Make sure that the screws are secured in the narrow sections of the holes. Tapping screw (Available at the hardware store) Fastener × 2 Diameter. 3.5 to 4 mm (1/8” to 3/16”) PLACING THE SPEAKERS For NS-B310 Min.
Note For NS-C310 ■Using as center speaker Place the speaker on a TV rack or other stable surface. To prevent the speaker from falling down, attach the fasteners provided in each corner of the speaker’s underside. Placing this unit too close to a CRT TV set might impair picture color or create a buzzing noise. Should this happen, move the speaker away (more than 20 cm (7-7/8”)) from the TV set. When using a PDP or LCD TV, it would not happen. WARNING • NS-C310 weighs 2.9 kg (6 lbs. 6 oz.).
CONNECTIONS TO YOUR AMPLIFIER ■How to connect 1 2 Before making connections, make sure that the amplifier is switched off. Loosen the knob. Remove 10 mm (3/8”) of insulation from each end of the cables, and twist the exposed conductors together neatly and tightly, as shown below. 10 mm (3/8 ”) Loosen Tighten Red (+) Good Black (–) 3 4 NS-C310 No Good Insert the bare wire. Tighten the knob and secure the cables. Test the firmness of the connection by pulling lightly on the cables at the terminal.
REMOVING THE FRONT COVER The front cover is attached to protect the speaker, but you can remove it if necessary. The front cover is fixed by magnets. Hold the speaker with one hand, and pull the front cover gently with the other to remove it. NS-B310 SPECIFICATIONS NS-B310 Type .................... full-range acoustic suspension speaker system Non-Magnetic shielding type Driver .......................................8 cm (3-1/8”) cone full-range × 2 Impedance ...............................................
Limited Guarantee for European Economic Area (EEA) and Switzerland Thank you for having chosen a Yamaha product. In the unlikely event that your Yamaha product needs guarantee service, please contact the dealer from whom it was purchased. If you experience any difficulty, please contact Yamaha representative office in your country. You can find full details on our website (http://www.yamaha-hifi.com/ or http://www.yamaha-uk.com/ for U.K. resident).
拆卸前盖 规格 安装前盖是为了保护扬声器,如有需要可将其拆下。 NS-B310 前盖由磁体固定。一手扶住扬声器,另一手轻拉前盖将其拆 下。 类型 ....................... 全频声学悬挂式扬声器系统 非磁屏蔽型 驱动单元 ......................... 8 cm 锥形全频 × 2 阻抗 ........................................... 6 Ω 频率响应 ................... 80 Hz 至 35 kHz (-10 dB) 至 50 kHz (-30 dB) 标称输入功率 ................................... 40 W 最大输入功率 .................................. 120 W 灵敏度 ............................... 87 dB/2.83 V/m 尺寸 (宽×高×深)............. 107 × 200 × 127 mm 重量 ...................................