User Manual
6 En
English
Before making connections, make sure that the
amplifier/receiver is switched off.
• When connecting, also refer to the owner’s manual of the
connected equipment.
• Connect the push input terminals at the rear of the
speaker to the speaker output terminals of the amplifier/
receiver with the speaker cables (not included).
• Be sure to connect the left channel (L), right channel
(R), “+” (red) and “–” (black) properly. If the speaker is
connected with reversed polarity, the sound will be
unnatural and lack bass.
1 Remove approximately 10 mm (3/8”) of insulation
from the end of each speaker cable using wire
strippers, and then twist the exposed wires of the
cable together to prevent short circuits.
2 Press and hold down the speaker terminal.
3 Insert the bare wire into the hole in the side of
each terminal.
4 Release the terminal.
• Test the firmness of the connection by pulling lightly on
the cable at the terminal.
CAUTION
• Do not let the bare speaker wires touch each other as this
could damage the speaker or amplifier/receiver, or both.
• Lower the power amplifier/receiver volume control
before changing input sources. Never change input
sources (for example, FM to CD) at high listening
levels. Always turn the receiver/amplifier unit off when
installing or removing any cables.
• Anytime you note distortion, reduce the volume
control on your power amplifier/receiver to a lower
setting. Never allow your power amplifier to be driven
into “clipping”.
The speaker grille can be painted to match your room
décor. Use high quality spray paint and select a well
ventilated area before proceeding.
1 Carefully remove the grille from the speaker if
attached.
2 Remove the scrim cloth that is attached to the
back of the grille. (The adhesive that holds the
cloth in place is reusable.)
3 Apply the paint to the grille.
• Make sure that the grille holes remain free of paint.
• Clogging the holes with paint may diminish the sound
quality.
4 When the paint has fully dried, re-attach the
scrim cloth to the back of the grille.
5 Re-install the grille on the speaker.
* Specifications subject to change without notice due to
product improvements.
* Speaker cables are not included with this model.
CONNECTING YOUR AMPLIFIER/RECEIVER
Connections
How to connect
1
2
3
10mm
(3/8")
No Good
Good
-
+
A
LR
B
+
-
+
-
+
-
Ⓡ
Ⓛ
NS-ICS600
Receiver or
amplifier
Speaker output
terminals
After connecting
PAINTING THE SPEAKER GRILLE
SPECIFICATIONS
NS-ICS600
Type 2-way Open back type
Driver
Tweeter 2.5 cm (1”) Soft dome type u 2
Woofer 16 cm (6.5”) Cone type (Dual voice coil)
Frequency response 65 Hz to 28 kHz (-10dB)
Impedance 8 ohms
Nominal input 20 W u 2
Maximum input 60 W u 2
Sensitivity 89 dB / 2.83 V, 1 m
Crossover frequency 3.2 kHz
Dimensions (with grille) I242 u 119D mm (I9-1/2” u 4-5/8”D)
Weight (with grille) 1.8 kg (4 lbs)
'0A;#/#*#AURGCMGTHOࡍࠫ㧞㧜㧝㧜ᐕ㧤㧢ᣣޓ㊄ᦐᣣޓඦ೨㧤ᤨ㧠ಽ