Owner's Manual

10 En
1 A (STANDBY/ON)
This switches the unit’s power between on and
standby.
2 Service port
This is for service, and is not normally used.
3 CONNECT
This is used for the following operations.
4 WIRELESS switch
This turns the wireless communication functionality
(wireless LAN) on/off.
AUTO:
Wireless communication is on.
OFF:
Wireless communication is off. If connecting the unit
to a network, use a wired connection. (→ p. 14 “If
connecting via a cable”)
5 INPUT switch
This switches the unit’s type of connection.
NET:
Choose this if you’re connecting the unit to a network.
ANALOG:
Choose this if you’re connecting the unit directly to an
amp or similar device, without connecting to a
network.
6 INPUT (ANALOG) jack
Use this if the INPUT switch is set to ANALOG.
Connect a cable from the amp’s subwoofer jack or line
output jack (such as PRE OUT) to this jack.
(→ p. 14 “If connecting via a cable”)
7 Service ports
These are for service, and are not normally used.
8 NETWORK port
Use a network cable (commercially available) to
connect to your network via a cabled connection.
PARTS AND THEIR FUNCTIONS
Rear panel
13245 867
● Registering this unit on the
MusicCast network
→ p. 15
● Updating the firmware
→ p. 18
● Initializing the settings
(factory reset)
→ p. 19