ABLH Subwoofer NS-SW100/NS-SW050 OWNER’S MANUAL EN
Thank you for selecting this Yamaha product. CAUTION: Read this before operating your unit Please read the following operating precautions before use. Yamaha will not be held responsible for any damage and/ or injury caused by not following the cautions below. • To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.
This unit is not disconnected from the AC power source as long as it is connected to the wall outlet, even if this unit itself is turned off. In this state, this unit is designed to consume a very small quantity of power. For U.K. customers If the socket outlets in the home are not suitable for the plug supplied with this appliance, it should be cut off and an appropriate 3 pin plug fitted. For details, refer to the instructions described below.
CONTENTS FEATURES ........................................................................ 1 CONTROLS AND THEIR FUNCTIONS CONTROLS AND THEIR FUNCTIONS.......................... 1 PLACEMENT..................................................................... 2 CONNECTIONS ................................................................ 3 Connecting to such as subwoofer output terminal or line output (pin jack) terminals of the amplifier........ 3 Plug in the subwoofer to the AC outlet .....................
PLACEMENT Since the low-end frequencies of audio signals feature long wavelengths, they are almost non-directional to human ears. The super-bass range does not create a stereo image. Therefore, a single subwoofer may be enough to produce a highquality super-bass sound. Note A The placement shown in the figure on the right is also possible.
CONNECTIONS Note • Unplug the subwoofer and other audio/video components before making connections, and do not plug them in until all connections are completed. • Connecting methods and terminal names on your component (such as an amplifier or receiver) may be different from those used in this book. Please refer to the owner’s manual that came with your component. • After connecting, make sure that cable is connected firmly.
ADJUSTING THE SUBWOOFER BEFORE USE Before using the subwoofer, adjust the subwoofer to obtain the optimum volume balance between the subwoofer and the front speakers by following the procedure described below. 1 2 3 Set the VOLUME control to minimum (0). Turn on the power of all the other components. Make sure that the POWER switch is set to the ON position. * The Power indicator lights up in green.
ADVANCED YAMAHA ACTIVE SERVO TECHNOLOGY II In 1988, Yamaha brought to the marketplace speaker systems utilizing YST (Yamaha Active Servo Technology) to give powerful, high quality bass reproduction. This technique uses a direct connection between the amplifier and speaker, allowing accurate signal transmission and precise speaker control.
TROUBLESHOOTING Refer to the chart below if this unit does not function properly. If the instructions given below do not help, or if the problem you are experiencing is not listed below, turn off the power to the unit, disconnect the power cord and contact an authorized Yamaha dealer or service center. Problem Cause What to Do Power is not supplied even though the POWER switch is set to the ON position. The power plug is not securely connected. Connect it securely. No sound.
SPECIFICATIONS ■ NS-SW100 Type........Advanced Yamaha Active Servo Technology II Driver ........................................ 25 cm (10") cone woofer Non magnetic shielding type Amplifier Output (100 Hz, 5 ohms, 10% THD).... 50 W Dynamic Power .............................................. 100 W, 5 Ω Frequency Response ................................ 25 Hz - 180 Hz Power Supply Australia model.................................AC 240 V, 50 Hz U.K. model........................................
Yamaha Global Site http://www.yamaha.com/ Yamaha Downloads http://download.yamaha.