User Manual

53
Continued on next page
If you are having diculty operating the Disklavier, see if any of the symptoms listed below apply to your problem and follow the recommended remedy.
Monitor Speaker
Symptom Remedy
No sound is heard from the monitor speaker. Make sure that the POWER switch on the monitor speaker is turned on.
Make sure that the monitor speaker is connected to the OUTPUT jacks on the control center unit with the supplied
speaker cord.
Make sure that the overall volume is adequately turned up.
Make sure that “Ensemble TG Volume” and “Audio Volume” are adequately turned up.
Playback
Symptom Remedy
The Disklavier cannot read a Song le. Make sure that the name of the SMF Song has the extension of “.mid” and the Audio Song has “.wav” or “.mp3.”
Check the number of the albums in one category. The maximum number of the readable albums in one category is 499.
Check the number of the Songs in an album. The maximum number of the readable Songs in an album is 999.
Check the number of the folder directory. The unit can recognize folders up to the third directory.
Songs are played back at the wrong tempo. Check the tempo setting.
Songs are not played back in the normal Song order. Make sure that the shue repeat mode is off.
Some notes drop out during playback. When a Piano Song is played back at a low volume, complex note trills and faint pianissimo passages sometimes drop
out. If so, increase the Disklavier’s volume level.
The damper does not operate during playback. Make sure that the pedal part is not canceled.
If a song that uses heavy pedaling is played back continuously for a long time, this unit may overheat, and the
protection circuit may be activated, and pedal playback may stop. If pedal playback stops, stop playback of the Song
and allow the unit to rest and fully cool down.
Troubleshooting