Getting Started Guide

Appendix
NUAGE MASTER Getting Started 17
Specifications
ELECTRICAL CHARACTERISTICS
All level controls are the nominal position. Output impedance of signal generator:150ohms. 0dBu = 0.775Vrms
ANALOG INPUT CHARACTERISTICS
ANALOG OUTPUT CHARACTERISTICS
CONTROL I/O CHARACTERISTICS
input output RL CONDITIONS MIN TYP MAX UNITS
Frequency
Response
TO PHONES Phones A or B 8Ω
Phones level control max,
Input level +4dBu(typ),
20Hz-20kHz, ref to the nominal
output level @1kHz
-3 0.0 0.5 dB
Total Harmonic
Distortion
*1
TO PHONES Phones A or B 8Ω
+4dB@20Hz-20kHz,
Phones level control max
0.04 %
Hum&Noise
*2
TO PHONES Phones A or B 8Ω
residual output noise,
Phones level control min
-100 dBu
Crosstalk@1kHz
*3
CH L Phones out CH R –
L/R, adjacent inputs
-80 dB
CH R Phones out CH L –
CONDITIONS MIN TYP MAX UNITS
Power
Requirements
US/Canada: 120V 60Hz
Japan: 100V 50/60Hz
China: 110-240V 50/60Hz
Korea: 220V 60Hz
Other: 110-240V 50/60Hz
30 W
Temperature range
Operating temperature range 0 40 °C
Storage temperature range -20 60 °C
Input
Terminals
Actual Load
Impedance
For Use With
Nominal
GAIN
Input level
Connector in Console
Nominal
Max. before
clip
TO PHONES 20KΩ (BAL) 150Ω Lines 0dB
+4dBu
(1.23 V)
+30dBu
(24.56 V)
XLR3-31type connectors
*4
Output
Terminals
Actual Source
Impedance
For Use With
Nominal
GAIN
SW
Output level
Connector in Console
Nominal
Max. before
clip
PHONES A 100Ω
8Ω Phones – 4mW 25mW
Stereo Phone Jack (TRS)
(Unbalanced)
*5
40Ω Phones – 12mW 75mW
PHONES B 100Ω
8Ω Phones – 4mW 25mW
Stereo Phone Mini Jack (TRS)
(Unbalanced)
*5
40Ω Phones – 12mW 75mW
TALKBACK OUT 75Ω 600Ω Lines –
+4dBu
(1.23 V)
+24dBu
(12.3 V)
XLR-3-32 type (Balanced)
*4
Terminal Format Connector in Console
NETWORK IEEE802.3 (10Base-T/100Base-TX) RJ-45
REMOTE RS-232C D-SUB Connector 9P (Male)