User Manual

Troubleshooting (in setting up)
12 NUAGE FADER Getting Started
Troubleshooting
(in setting up)
Power does not turn on
• Is [Power switch] turned on?
• Is the power cable connected to a proper AC outlet?
• Is the power cable plug inserted all the way?
If the power still does not turn on, contact your Yamaha
dealer.
Device is not communicating with
Nuendo
• Is the Ethernet cable connected properly?
• Has “Installing TOOLS for NUAGE” (page 11) already
been completed?
• Has “Configuring the Workgroup on NUAGE” (page 11)
already been completed?
• Have the fire wall settings been set property?
• If a network adaptor for wireless LAN running, disable
the suspected network adaptor.
The Mixer window from the LCD
set up for Nuage Fader is being
shown on another LCD
• When Nuage Fader’s [SHIFT], [CTRL], and [ALT]
buttons are held down simultaneously, buttons [1] to [8]
from the SECTION CONTROL section will indicate the
number of the LCD showing the Mixer window. By
pressing a dimly-lit button, you can change the LCD on
which the Mixer window is shown.
In the LCD or organic EL display,
there are some black points (unlit)
or white points (always lit)
• These are the result of defective pixels and occasionally
occur in the display; they do not indicate a problem in
operation.
The touch sensitivity of the knob
or fader is too high/low
• Change the touch sensitivity setting referring to
“Adjusting the Touch Sensitivity” (page 13).
The brightness of the button or
touch screen is too bright/dark
• Change the brightness setting referring to “Specifying
the Brightness” (page 14).
Discrepancy occurs in the motion
of the faders
• Operate the adjustment of the fader motion referring to
“Calibrating Fader Motion or Position” (page 14).