User Manual

Added functions in NUAGE V1.5 98
3 Identify
Searches for the Dante Accelerator specified with “Dante
Interface”. When “Identify” is clicked, all LEDs for the
specified Dante Accelerator flash for a few seconds
simultaneously, and then stops automatically.
4 Refresh
Refreshes the direct monitoring channel list.
5 +/- (Show/Hide Channel)
Shows (+) or hides (-) the channels assigned to the bus.
6 Number of channels available for direct
monitoring
Shows the number of channels available for direct
monitoring.
7 Direct monitoring channel list
Shows the “Bus Name”, “Bus Type”, and “Device Port” of
buses selected for direct monitoring.
“Bus Type” shows if the channel selected for direct
monitoring is assigned to Output or Studio (Control
Room). You can remove a bus by selecting it under “Bus
Name”, right clicking, and then selecting [Delete] from the
context menu.
NOTE
See the following website for more information and cautions to
observe when using direct monitoring.
http://www.yamahaproaudio.com/
Added selection function for
Ethernet port to use with Avid
Pro Tools (NUAGE PT Bridge)
To use the Nuage controller as a control surface for Avid
Pro Tools, you must first configure NUAGE PT Bridge.
In previous versions, the Ethernet port connection function
for NUAGE PT Bridge was always selected automatically.
In some cases, this resulted in wireless LAN being
selected.
In this version, manual selection has been added so that it
is easier to select the Ethernet port on the computer.
To select the Ethernet port, on the computer select
[System Preferences] [NUAGE PT Bridge].
Network Screen
1 Configure
Set “Network Interface” to either Automatically or
Manually.
2 Network Interface
Select the port for connecting NUAGE series devices.
This option becomes available when “Configure” is set to
“Manually”.
About Screen
Shows the information for NUAGE PT Bridge.
1
2