User Manual

Keyboard Stand Assembly
32
YDP-S34 Owner’s Manual
CAUTION
Be sure to attach the anti-fall brackets to the instrument, to
ensure stability. Failure to do so might result in damage to the
instrument or even injury.
3. Secure C.
3-1 Securely tighten the screws on C that were
attached in Step 1-3.
3-2 Attach the caps ( 6 ) to the head of the screws.
4. Mount A.
Be sure to place your hands at least 10 cm from
either end of A when positioning it.
Align the dowels on D and E with the
corresponding holes on the bottom of A.
CAUTION
• Be careful not to pinch your fingers or drop the unit.
• Make sure to keep your hands more than 10 cm distant from
the ends of A when positioning the unit, to avoid pinching
your fingers.
• Do not hold the keyboard in any position other than the
position shown in the illustration.
5. Secure A.
5-1 Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2 Secure A by tightening the short screws 3
(6 x 16 mm) from the bottom.
6. Connect the pedal cord.
6-1 Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
6-2 Securely wind the cord holder around the
pedal cord.
The cord holder is attached to D.
6-3 Use a vinyl tie (Step 1-1) to take up any
slack in the pedal cord.
2-1, 2-4
2-3
2-2
2-2
D
E
B
Secure the anti-fall brackets (7) using the screws.
C
B
3-2
3-1
DE
A
DEB
At least 10 cm At least 10 cm
5-1
A
A
5-2
Projection of A