User Manual

Keyboard Stand Assembly
36
YDP-164, YDP-144, YDP-S54 Owner’s Manual
6. Connect the pedal cord and the AC
adaptor.
6-1 Insert the pedal cord plug to the
[TO PEDAL] jack from the rear.
6-2 Securely wind the cord holder around the
pedal cord.
The cord holder is attached to D.
6-3 Insert the AC adaptor plug into the DC IN
jack from the rear.
7. Set the adjuster.
Rotate the adjuster until it comes in firm contact
with the floor surface.
(YDP-164 only)
8. Attach the headphone hanger.
Use the included two screws (4 x 10 mm) to attach
the hanger as shown in the illustration.
NOTICE
Do not hang anything other than the headphones on the
hanger. Doing so may damage this instrument or the hanger.
Insert the pedal cord securely until the metal part of the
cord plug disappears from view. Otherwise, the pedal may
not function properly.
6
-
1
6
-
3
6
-
2
After completing the assembly, make sure to confirm the
list of post-assembly questions on page 33.