User Manual

Keyboard Stand Assembly
38
YDP-164, YDP-144, YDP-S54 Owner’s Manual
3. Secure C.
3-1 Securely tighten the screws on C that were
attached in Step 1-3.
3-2 Attach the caps to the head of the screws.
4. Mount A.
Be sure to place your hands at least 10 cm from
either end of A when positioning it.
Align the dowels on D and E with the corresponding holes
on the bottom of A.
CAUTION
• Be careful not to pinch your fingers or drop the unit.
• Make sure to keep your hands more than 10 cm distant from
the ends of A when positioning the unit, to avoid pinching
your fingers.
• Do not hold the keyboard in any position other than the
position shown in the illustration.
5. Secure A.
5-1 Adjust the position of A so that the left and
right ends of A will project beyond D and E
equally when seen from the front.
5-2 Secure A by tightening the short screws (6 x
16 mm) from the bottom.
6. Secure F.
Position F so that the side without felt faces the
player. Secure F by tightening two thin screws (4 x
12 mm).
3-2
3-1
At least
10 cm
At least
10 cm
5-1
5-2
Projection of A
Felt
Rear of F