Owner's Manual

P-515 Owner’s Manual

Connections

Connecting by the Accesspoint Mode

Make sure to connect the USB wireless LAN adaptor (sold separately) to the

[ ] (USB TO DEVICE) terminal, otherwise the displays for setup will not

be shown.

1. Switch the instrument to the “Accesspoint Mode.”

Press the [FUNCTION] button repeatedly to call up the “System” menu

display, then select the highlighted item in each display as illustrated

below.

When mode change is done successfully, “Completed” is shown in the

display, operation returns to the “Wireless LAN Mode” display.

2. Set SSID, Security, Password and Channel.

2-1. From the “System” menu display, select the highlighted item

in each display as illustrated below.

2-2. Set the SSID, Security, Password and Channel.

Select and enter each value/setting in the same way as in step 3 in

“Manual Setup.” For the setting range for each item, refer to the table on

page 104.

NOTE

This cannot be used to connect

to the internet or another

wireless LAN device.

“System” menu display

1-1. Use the [u]/[d] buttons

to select “Utility.”

1-2. Press the [>] button to

call up the next display.

1-3. Use the [u]/[d] buttons to

select “Wireless LAN Option.”

1-4. Press the [>] button to call up

the next display.

1-5. Use the [u]/[d] buttons to

select “Wireless LAN Mode.”

1-6. Press the [>] button to call

up the next display.

“Utility” display

“Wireless LAN Option” display

1-7. Use the [u]/[d] buttons to

select “Accesspoint Mode.”

“Wireless LAN Mode” display

“System” menu display “Utility” display “Wireless LAN” display