User Manual

5.10. AMP SETTINGS page
This shows information for the basic amp-related settings.
① SENS./GAIN
This shows the input sensitivity or gain specified by SENS./GAIN.
② MODE (PC-DI series only)
This shows the MODE (Lo-z, 70V, 100V) of the speaker to be connected.
③ HPF (Hi-Z) (PC-DI series only)
If MODE (②) is 70V or 100V, this shows the cutoff frequency (40 Hz, 80 Hz) of the HPF (high pass filter) that is
compulsorily applied.
Use the channel select keys to select the channel that you want to operate, and then press the main knob to
access the AMP SETTINGS screen.
5.11. LOAD MONITORING page
This shows the impedance that is detected by LOAD MONITORING (Lo-z only).
① ON/OFF
This indicates whether speaker impedance is monitored (ON) or not (OFF).
② Impedance
This shows the measured impedance.
Use the channel select keys to select the channel that you want to operate, and then press the main knob to
access the LOAD MONITORING screen.
5. Panel operations
26 | PC412-D PC412-DI PC406-D PC406-DI Owner’s Manual