User Manual

9.3. CONTROL
Here you can make settings related to remote control.
① IP SET. (IP SETTINGS)
This selects how the IP address is set.
• UNIT ID: 192.168.0. ### is set (###＝UNIT ID).
• DHCP: The IP address assigned by the DHCP server is set. The IP address, NETMASK, and GATEWAY are
obtained automatically. If there is no DHCP server on the network, the unit operates using a link local address
(169.254.xxx.xxx).
• STATIC IP: The IP address is specified manually.
② IP ADR.
This shows the IP address. If STATIC IP is selected in IP SET., specify the IP address here.
③ NETMASK
This shows the subnet mask. If STATIC IP is selected in IP SET., specify the subnet mask address here.
④ GATEWAY
This shows the default gateway.
Depending on the setting of IP SET.(①), this is shown as follows.
• UNIT ID: Default gateway is disabled
• STATIC IP: Default gateway is set manually
⑤ MAC
This shows the MAC address. This address is only displayed, and cannot be changed.
9. NETWORK screen
PC412-D PC412-DI PC406-D PC406-DI Owner’s Manual | 55