User Manual

Symptom Possible causes Possible solution
You want to return the parameter
settings to their initial values.
- To return to the initial settings,
execute "Returning to the factory
settings (Initialization)".
The edited current parameter
returns to the unedited value when
the power is turned off and the unit
is restarted.
The power was turned off before the
current parameter was
automatically saved.
Before turning the power off, wait at
least three seconds after an editing
operation.
Can’t patch the unit with a CL series
digital mixer using Dante Controller.
The CL series unit’s Fs setting is 48
kHz, and this unit’s setting is 96
kHz.
In Dante Controller or on this unit,
set the Fs to match the setting of
the CL series unit.
When you execute Clear Config in
Dante Controller, operation
becomes unstable.
After Clear Config is executed, the
unit will not operate correctly until it
is restarted.
If you executed Clear Config, you
must restart using one of the
following methods.
- When executing Clear Config in
Dante Controller, put a check mark
in [Reboot]
- After executing Clear Config, turn
this unit’s power off and then on
again
- After executing Clear Config,
execute UTILITY > REBOOT from the
screen of this unit
13. Reference
84 | PC412-D PC412-DI PC406-D PC406-DI Owner’s Manual