User Manual

15
Returning to the factory settings (initialization)
There are two ways to initialize this product.
Initialization by MENU screen →
UTILITY → selecting INITIALIZE
1. In the MENU screen, turn the main knob to select
“UTILITY,” and press the main knob to confirm.
The UTILITY screen appears.
2. In the UTILITY screen, turn the main knob to select
“INITIALIZE,” and press the main knob to confirm.
The INITIALIZE screen appears.
3. Turn the main knob to choose the type of settings that
will be initialized (multiple selections are possible),
and press the main knob to confirm.
The following table shows what can be initialized.
4. When you have finished making selections, turn the
main knob to move to [OK], and press the main knob
to confirm.
5. In the confirmation screen, turn the main knob to
select “YES,” and press the main knob to confirm.
When initialization is completed, the unit restarts automat-
ically, and then enters the power-on state.
Initialization if you have forgotten the
PIN code, etc.
If you are unable to select INITIALIZE in the UTILITY screen,
for example if you have forgotten the PIN code for the panel
lock, you can initialize using the following method.
1. Disconnect the unit from the AC outlet.
2. While holding down channel select key [A] and the
[ ] (back) key, connect the unit to the AC outlet.
The confirmation screen appears.
3. Press the main knob to confirm.
Initialization begins. During initialization, all channel indica-
tors are lit red.
When initialization is completed, all channel indicators are lit
green, the unit restarts automatically, and then enters the
standby state.
AMP/PROCESSING
PROCESSING
SETUP
UTILITY
AMP PRESET AMP PRESET
NETWORK
IP SETTING
DANTE SETTINGS, UNIT ID
AMP/PROCESSING is always initialized.
NOTE