Plasma Monitor User's Manual

AV1 AV2
RGB 1 RGB 2
AV3
MUTE VOL
VOL
AV4
AUTO PinP
OK
SIZE RECALL
MENU
ID
ID SET
9
ENGLISH
Remote control
ID SET button
16
POWER OFF button
13
POWER ON button
13
POWER ON/OFF button
13
MENU button
16
MUTE button
14
VOLUME UP/DOWN buttons
14
RETURN button
16
RECALL button
15
AUTO button
16
PinP button
34
ID button
16
SELECT/ADJUST buttons
16
OK button
16
Loading Batteries
1. Open the battery cover.
Slide back and remove the battery
cover in the direction of the arrow.
2. Load the batteries.
Load the two Size AA batteries included, matching polarity
markings on the batteries to those on
the case.
3. Close the battery cover.
Replace the battery cover in the direction of the arrow and snap
it back into place.
Use the remote control within about 5 m from the front of the unit,
within a 30 degree arc either side of the remote control sensor.
With in 30
degrees
About 5m
About 3m
With in 30
degrees
About 3m
AV1 AV2
RGB 1 RGB 2
AV3
MUTE VOL
VOL
AV4
AUTO PinP
OK
SIZE RECALL
MENU
ID
ID SET
CAUTION
Do not use new and old batteries together. The batteries could
explode or leak, resulting in fires, physical injury, or stains.
When loading batteries, observe their correct polarities as
marked on the product. If loaded in the wrong direction, the
batteries could explode or leak, resulting in fires, physical injury,
or stains.
ATTENTION
Do not drop exert undue force on the remote control.
To avoid possible failures. Do not splash the remote control with
water or put it on a wet object.
It you do not intend to use the remote control for an extended
period of time, remove the batteries from it.
If the remote control begins to lack responsiveness, replace the
batteries.
Strong light such as direct sunlight impinging on the
photoreceptor of the remote control can cause operational
failure. Position this unit to avoid direct contact with such light.
Handling the Remote Control
SIZE button
15
RGB/VIDEO buttons
14
COMPONENT NAMES
(continued)
012_PDM-4210_G_ENG 2003.12.24 01:15 ページ 9 (ブラック 版)