Conference Phone User Manual
Table Of Contents
- Important Safety Instructions
- Caution: Read This Before Operating Your Unit.
- Contents
- Features
- About this Manual
- Preparation Procedure
- Configuring the Settings
- Setting the Menu List
- Registering the IP network information
- Setup of telephone function
- Configuring the sound settings
- Configuring the general settings
- Adjusting the ring tone volume
- Controlling the system using the remote operation function
- Configuring the backlight off setting
- Adjusting the LCD contrast
- Selecting the menu language (Language)
- Setting the date and time manually
- Setting the time zone
- Setting the daylight saving time
- Selecting the SNTP server for synchronization
- Selecting the SNTP synchronization interval
- Call history management
- Setting the password
- Calling a ProjectPhone system in the same subnet
- Setting the Date and Time
- Editing the Address Book
- Using the SIP Server
- Hierarchical Connection of Multiple ProjectPhone (Cascade Connection)
- Interlocked Connection of ProjectPhone Systems
- Connection Using Audio Connection Cables
- Updating the Firmware
- Troubleshooting
- Resetting this Unit
- Obtaining the Setting Information for Support on this Unit
- Confirming the System Log Message of This Unit (Syslog)
- Specifications
- Notes on Transferring/Disposing this Unit
Preparation Procedure
8
8 Use the numeric keys to enter the IP address
of this unit, and then press .
The entered IP address is registered, and the
“Network Settings” menu reappears.
Set an IP address that does not overlap with the IP address
of another piece of equipment connected to the LAN.
9 Press or to select “Subnet Mask”, and
then press .
The “Subnet Mask” menu appears.
10 Use the numeric keys to enter the subnet
mask of this unit, and then press .
The entered subnet mask is registered, and the
“Network Settings” menu reappears.
11 Press or to select “Default Gateway”, and
then press .
The “Default Gateway” menu appears.
12 Use the numeric keys to enter the “Default
Gateway” of this unit, and then press .
The entered “Default Gateway” is registered, and the
“Network Settings” menu reappears.
13 Press or to select “DNS Server”, and
then press .
The “DNS Server” menu appears.
Note
3. Subnet Mask
2. IP Address
1. DHCP
Network Settings
(255.255.255.000)
[ ] [#]
255.255.255.000
^
Subnet Mask
4. Default Gateway
3. Subnet Mask
2. IP Address
Network Settings
(000.000.000.000)
[ ] [#]
000.000.000.000
Default Gateway
^
5. DNS Server
4. Default Gateway
3. Subnet Mask
Network Settings
(000.000.000.000)
[ ] [#]
000.000.000.000
DNS Server
^