Conference Phone User Manual
Table Of Contents
- Important Safety Instructions
- Caution: Read This Before Operating Your Unit.
- Contents
- Features
- About this Manual
- Preparation Procedure
- Configuring the Settings
- Setting the Menu List
- Registering the IP network information
- Setup of telephone function
- Configuring the sound settings
- Configuring the general settings
- Adjusting the ring tone volume
- Controlling the system using the remote operation function
- Configuring the backlight off setting
- Adjusting the LCD contrast
- Selecting the menu language (Language)
- Setting the date and time manually
- Setting the time zone
- Setting the daylight saving time
- Selecting the SNTP server for synchronization
- Selecting the SNTP synchronization interval
- Call history management
- Setting the password
- Calling a ProjectPhone system in the same subnet
- Setting the Date and Time
- Editing the Address Book
- Using the SIP Server
- Hierarchical Connection of Multiple ProjectPhone (Cascade Connection)
- Interlocked Connection of ProjectPhone Systems
- Connection Using Audio Connection Cables
- Updating the Firmware
- Troubleshooting
- Resetting this Unit
- Obtaining the Setting Information for Support on this Unit
- Confirming the System Log Message of This Unit (Syslog)
- Specifications
- Notes on Transferring/Disposing this Unit
USING THE SIP SERVER
24
If this unit is used in an environment with a SIP server, the
address of the SIP server to be referenced by this unit and
the SIP address of this unit should be registered. If
password authentication is required for accessing the
desired SIP server, it is also necessary to enter the
password. Consult your system administrator for details.
The settings described in this section are not required if this unit
is used in an environment without a SIP server.
1 In the Web menu, click “SIP Server”.
The “SIP Server” window appears.
2 In the “SIP Server”, click “Enable”.
3 In the “SIP Server Name”, enter the name or
IP address of the SIP server.
4 If password authentication is required for
accessing the desired SIP server, enter the
authentication password for the SIP server in
the “SIP Server Password”.
5 In the “SIP Address”, enter the SIP address
to be set to this unit.
Enter the SIP address in the format
“sip:(sip address)”.
Example: sip:sipuser@yamaha.co.jp
6 Click “Submit”.
The setting is registered and the top window of the
Web menu reappears.
• To connect a call using the SIP server, the SIP address
of this unit should be registered in the SIP server.
• It is not possible to establish a connection between a
ProjectPhone system that uses the SIP address and a
ProjectPhone system that uses the IP address.
• A global IP address should be assigned to the WAN on
the router side.
Using the SIP Server
Registering the SIP server
information
Note
Notes on SIP server operation
1
2
3
4
5
6
7
8
9
0
MIC MUTE
VOL
1
2
3
4
5
6
7
8
9
0
MIC MUTE
VOL
1
2
3
4
5
6
7
8
9
0
MIC MUTE
VOL
Branch A
Router
Router
Branch B
Router
SIP server
Headquarter