Conference Phone User Manual
Table Of Contents
- Important Safety Instructions
- Caution: Read This Before Operating Your Unit.
- Contents
- Features
- About this Manual
- Preparation Procedure
- Configuring the Settings
- Setting the Menu List
- Registering the IP network information
- Setup of telephone function
- Configuring the sound settings
- Configuring the general settings
- Adjusting the ring tone volume
- Controlling the system using the remote operation function
- Configuring the backlight off setting
- Adjusting the LCD contrast
- Selecting the menu language (Language)
- Setting the date and time manually
- Setting the time zone
- Setting the daylight saving time
- Selecting the SNTP server for synchronization
- Selecting the SNTP synchronization interval
- Call history management
- Setting the password
- Calling a ProjectPhone system in the same subnet
- Setting the Date and Time
- Editing the Address Book
- Using the SIP Server
- Hierarchical Connection of Multiple ProjectPhone (Cascade Connection)
- Interlocked Connection of ProjectPhone Systems
- Connection Using Audio Connection Cables
- Updating the Firmware
- Troubleshooting
- Resetting this Unit
- Obtaining the Setting Information for Support on this Unit
- Confirming the System Log Message of This Unit (Syslog)
- Specifications
- Notes on Transferring/Disposing this Unit
27
Hierarchical Connection of Multiple ProjectPhone (Cascade Connection)
CONFIGURATIONS
English
First configure the setting of the cascade server unit, and
then configure the settings of the cascade client units.
■ Setup of the cascade server
1 Press repeatedly until the initial display
appears.
2 Press .
The menu screen appears.
3 Press or to select “Settings”, and then
press .
The “Settings” menu appears.
4 Press or to select “Network Settings”,
and then press .
The “Network Settings” menu appears.
5 Press or to select “Connection Mode”,
and then press .
The “Connection Mode” menu appears.
6 Press or to select “Cascade Server”, and
then press .
The settings are saved.
Return to the initial display and check that is
displayed at the top of the display.
■ Setup of the cascade clients
Follow the procedure in “Setup of the cascade server”
above and select “Cascade Client” in step 6.
After completing the setting, return to the initial display
and check that is displayed at the top of the display.
Configuring the cascade settings
3. Online
2. Call History
1. Settings
Menu
3. Sound Settings
2. Phone
1. Network Settings
Settings
5. DNS Server
4. Default Gateway
6. Connection Mode
Network Settings
3. Cscd Client
2. Cscd Server
1. Mesh
Connection Mode