Conference Phone User Manual
Table Of Contents
- Important Safety Instructions
- Caution: Read This Before Operating Your Unit.
- Contents
- Features
- About this Manual
- Preparation Procedure
- Configuring the Settings
- Setting the Menu List
- Registering the IP network information
- Setup of telephone function
- Configuring the sound settings
- Configuring the general settings
- Adjusting the ring tone volume
- Controlling the system using the remote operation function
- Configuring the backlight off setting
- Adjusting the LCD contrast
- Selecting the menu language (Language)
- Setting the date and time manually
- Setting the time zone
- Setting the daylight saving time
- Selecting the SNTP server for synchronization
- Selecting the SNTP synchronization interval
- Call history management
- Setting the password
- Calling a ProjectPhone system in the same subnet
- Setting the Date and Time
- Editing the Address Book
- Using the SIP Server
- Hierarchical Connection of Multiple ProjectPhone (Cascade Connection)
- Interlocked Connection of ProjectPhone Systems
- Connection Using Audio Connection Cables
- Updating the Firmware
- Troubleshooting
- Resetting this Unit
- Obtaining the Setting Information for Support on this Unit
- Confirming the System Log Message of This Unit (Syslog)
- Specifications
- Notes on Transferring/Disposing this Unit
32
Connection Using Audio Connection Cables
The PC settings should be changed so that the audio input
from this unit to the PC is not output to this unit. It is
necessary to change the setup so that the audio input from
the connected terminal is accepted.
The options of Sound and Audio Devices Properties may differ
depending on the PC. When different from the following
instruction, refer to the instruction manuals of your PC or the
sound card installed to your PC, and set the parameters as
follows.
1 Click “Start” on the task bar, point to
“Settings”, and click “Control Panel”.
2 Click “Sounds, Speech and Audio Devices”.
3 Click “Sounds and Audio Devices”.
4 Click the “Audio” tab.
5 In the “Sound Playback” field, click
“Volume...”.
6 In the “Line In” field, click “Mute” to check it.
Setting of PC
Note
Click.
Click.
Click.
Click.
Select either check box.