User`s manual
Table Of Contents
- Contents
- Introduction
- CONFIRMATION SOFTWARE LICENSE AGREEMENT
- About the Product
- Controls and Functions
- Installation and Initial Setup
- Automatic Setup by Auto Analyzer
- Using the Web Menu
- Setting the Password
- Setting the Date and Time
- Configuring the Network Settings
- Limiting Access to the Web Menu
- Controlling Echoes
- Controlling Acoustic Feedback
- Controlling Noises
- Adjusting the Input Gain Automatically (Auto Gain Controller)
- Adjusting the Input Gain for MIC/LINE INPUT
- Adjusting the Volume Level
- Using the Internal Mixer
- Configuring the Phantom Power Settings
- Configuring This Unit's Settings Automatically (Auto Analyzer)
- Turning On/Off the Audio Guidance
- Maintenance and Management
- Special Functions
- Changing the Screen Color
- Using the Latest Features
- Troubleshooting
- List of Error Messages
- Resetting the Settings of This Unit
- Support Information
- Specifications
12
8 Configure the settings of this unit using
the DIP switch.
For details, refer to “Functions of the DIP switch”
(page 10).
9 Turn on the external devices.
10 Turn on this unit.
The POWER LED on the front panel turns on.
11 On your PC or videoconference system,
adjust the output level.
Adjust the output level so that the INPUT LEVEL
LED on the front panel does not turn on in red.
12 Use GAIN to adjust the input gain for
MIC/LINE INPUT.
Adjust the input gain so that the INPUT LEVEL LED
on the front panel does not turn on in red.
13 Press AUTO ANALYZER.
The echo canceller and feedback suppressor settings
are automatically adjusted. For details, refer to
“Automatic Setup by Auto Analyzer” (page 15).
• If you do not connect a microphone to MIC/LINE INPUT IN2,
set GAIN IN2 to the minimum.
• Set the microphone and speaker volumes to the minimum
before turning off this unit.
Notes