User`s manual
Table Of Contents
- Contents
- Introduction
- CONFIRMATION SOFTWARE LICENSE AGREEMENT
- About the Product
- Controls and Functions
- Installation and Initial Setup
- Automatic Setup by Auto Analyzer
- Using the Web Menu
- Setting the Password
- Setting the Date and Time
- Configuring the Network Settings
- Limiting Access to the Web Menu
- Controlling Echoes
- Controlling Acoustic Feedback
- Controlling Noises
- Adjusting the Input Gain Automatically (Auto Gain Controller)
- Adjusting the Input Gain for MIC/LINE INPUT
- Adjusting the Volume Level
- Using the Internal Mixer
- Configuring the Phantom Power Settings
- Configuring This Unit's Settings Automatically (Auto Analyzer)
- Turning On/Off the Audio Guidance
- Maintenance and Management
- Special Functions
- Changing the Screen Color
- Using the Latest Features
- Troubleshooting
- List of Error Messages
- Resetting the Settings of This Unit
- Support Information
- Specifications
13
PREPARATION
By combining this unit with a PA system, it makes possible to use many microphones for a conference.
1 Connect MIC/LINE INPUT IN1 of this unit
to the audio output jack of your PA
system.
2 Connect microphones to your PA
system.
3 Connect speakers with built-in amplifier
to LINE OUTPUT.
4 Connect CONFERENCE IN of this unit to
the audio output jack of your PC or
videoconference system.
5 Connect CONFERENCE OUT of this unit
to the audio input jack of your PC or
videoconference system.
6 Connect the AC adapter to DC IN.
7 Connect the power cable to the AC
adapter.
8 Connect the power cable to an AC outlet.
9 Configure the settings of this unit using
the DIP switch.
For details, refer to “Functions of the DIP switch”
(page 10).
10 Turn on the external devices.
11 Turn on this unit.
The POWER LED on the front panel turns on.
12 On your PC or videoconference system,
adjust the output level.
Adjust the output level so that the INPUT LEVEL
LED on the front panel does not turn on in red.
Using in combination with a PA system
RL
LINE OUTPUT
OUT IN
CONFERENCE MIC/LINE INPUT
MIN MAX
IN2
IN2 IN1
DC IN 12V
STANDBY ON
ETHER
DIP SW
AUTO
ANALYZER
INITIALIZE
PHANTOM
ACTIVE ACTIVE
OFFON
LINE
MIC
MIN MAX
IN1
ETHER
LINE
MIC
1
2
OFF
ON
PHANTOM
IN1 & 2
CONF.OUT
EC TYPE
MIX & FS
DIP SW
SETTING
8
2
1
13
14
11
5
4
3
9
6
7
GAIN
15