User`s manual

16
By using the web menu, you can configure this unit's settings in more detail. The web menu is accessible from the PC
connected to this unit. To configure this unit's settings from the web menu, set the DIP switch (DIP SW) to ETHER.
• If you set DIP SW to ETHER, the web menu settings are prioritized. The settings items you have configured using the DIP switch
should be reconfigured on the web menu. If you set the DIP switch to DIP SW after configuring the settings on the web menu, setting
items that are not available by the DIP switch are decided by the web menu settings.
• To access the web menu, Internet Explorer 6.0 (or later version) for Windows is required.
1 Connect this unit and your PC using the
LAN cable.
y
Since this unit automatically detects the type of a LAN
cable (straight or crossover), you can use a straight LAN
cable to directly connect this unit to a PC.
2 Turn on this unit and your PC.
3 Change the IP address of your PC as
follows.
IP address: 192.168.100.2
Subnet mask: 255.255.255.0
y
You can use an IP address within the range of
"192.168.100.1" to "192.168.100.254" (except
"192.168.100.101"). In this procedure, "192.168.100.2" is
used as an example.
4 On your PC, run the web browser and
then select "Open" from the "File" menu.
5 Enter "http://192.168.100.101" and then
click "OK".
The web menu is displayed.
Using the Web Menu
Notes
RL
LINE OUTPUT
OUT IN
CONFERENCE MIC/LINE INPUT
MIN MAX
IN2
IN2 IN1
DC IN 12V
STANDBY ON
ETHER
DIP SW
AUTO
ANALYZER
INITIALIZE
PHANTOM
ACTIVE ACTIVE
OFFON
LINE
MIC
MIN MAX
IN1
ETHER
LINE
MIC
1
2
OFF
ON
PHANTOM IN1 & 2 CONF.OUT EC TYPE MIX & FS DIP SW
SETTING
GAIN