User`s manual
Table Of Contents
- Contents
- Introduction
- CONFIRMATION SOFTWARE LICENSE AGREEMENT
- About the Product
- Controls and Functions
- Installation and Initial Setup
- Automatic Setup by Auto Analyzer
- Using the Web Menu
- Setting the Password
- Setting the Date and Time
- Configuring the Network Settings
- Limiting Access to the Web Menu
- Controlling Echoes
- Controlling Acoustic Feedback
- Controlling Noises
- Adjusting the Input Gain Automatically (Auto Gain Controller)
- Adjusting the Input Gain for MIC/LINE INPUT
- Adjusting the Volume Level
- Using the Internal Mixer
- Configuring the Phantom Power Settings
- Configuring This Unit's Settings Automatically (Auto Analyzer)
- Turning On/Off the Audio Guidance
- Maintenance and Management
- Special Functions
- Changing the Screen Color
- Using the Latest Features
- Troubleshooting
- List of Error Messages
- Resetting the Settings of This Unit
- Support Information
- Specifications
21
CONFIGURATIONS
According to the LAN environment where this unit is
used, configure the IP address netmask settings of this
unit.
y
"192.168.100.101/24" is assigned to the LAN port by
default. If you want to change the IP address, use an IP
address which is not used by other external devices in the
same network.
1 Click "IP Settings".
The "IP Settings" screen appears.
2 In the "LAN Port" field, click "Edit".
The "LAN Port Settings" screen appears.
3 Enter an IP address to assign to this
unit.
4 Click "Apply".
The confirmation screen appears.
5 Click on the link to access to the new IP
address and then click "Close".
The "Top Page" screen under the new IP address
appears.
Configuring the Network Settings
1. Specifying an IP address of this
unit's LAN port