User`s manual
Table Of Contents
- Contents
- Introduction
- CONFIRMATION SOFTWARE LICENSE AGREEMENT
- About the Product
- Controls and Functions
- Installation and Initial Setup
- Automatic Setup by Auto Analyzer
- Using the Web Menu
- Setting the Password
- Setting the Date and Time
- Configuring the Network Settings
- Limiting Access to the Web Menu
- Controlling Echoes
- Controlling Acoustic Feedback
- Controlling Noises
- Adjusting the Input Gain Automatically (Auto Gain Controller)
- Adjusting the Input Gain for MIC/LINE INPUT
- Adjusting the Volume Level
- Using the Internal Mixer
- Configuring the Phantom Power Settings
- Configuring This Unit's Settings Automatically (Auto Analyzer)
- Turning On/Off the Audio Guidance
- Maintenance and Management
- Special Functions
- Changing the Screen Color
- Using the Latest Features
- Troubleshooting
- List of Error Messages
- Resetting the Settings of This Unit
- Support Information
- Specifications
32
If the DIP switch (PHANTOM) is set to ON, you can
select whether to supply the phantom power thorough
MIC/LUNE IN1 and IN2.
Use the DIP switch (PHANTOM) to turn on the phantom power
only when a condenser microphone which requires an external
power supply is connected.
y
While the phantom power is turned on, DC+48V power is
supplied through pins 2 and 3 of the XLR jack (MIC/
LINE INPUT).
1 Click "Sound Settings".
The "Sound Settings" screen appears.
2 In the "Phantom Power" field, click
"Edit".
The "Phantom Power Settings" screen appears.
3 Configure the phantom power settings.
Enable: Supply the phantom power.
Disable: Not to supply the phantom power.
4 Click "Apply".
The confirmation screen appears.
5 Click "Close".
The "Sound Settings" screen appears again.
Configuring the Phantom Power Settings
Do not turn on the phantom power when a device which
does not require a phantom power is connected to MIC/
LINE INPUT. Incorrect settings may cause a
malfunction of the external devices. For your safety, the
phantom power is not supplied unless it is enabled on
the web menu even if the DIP switch (PHANTOM) is
set to ON.
Note