User Manual

Chapter 4. Basic operation for input channels
49
Sending signals from an input channel to a MIX bus
Here’s how to use the SELECTED INPUT CHANNEL block to send an input channel signal to a MIX bus.
By using the SELECTED INPUT CHANNEL block, you can simultaneously control the signals that are sent from a spe-
cific input channel to multiple MIX buses.
[Procedure]
1. In the LCD FUNCTION ACCESS block, press the
INPUT [PAN/ROUTING] switch several times to
access the CH to MIX screen. For each of the MIX
buses arranged in odd-numbered → even-num-
bered pairs, select the type (FIX/VARI) (→p.40).
Hint
If necessary, you can use the CH to MIX screen to
pair adjacent odd-numbered → even-numbered
MIX buses. In this case, the on/off setting, send level,
and PRE/POST selection will be linked for the signals
sent from each channel to the paired MIX buses.
2. Use the INPUT block [SEL] switch or the ST IN
block SEL [L]/[R] switch to select the input channel
from which the signal will be sent.
3. Use the SELECTED INPUT CHANNEL block MIX
SEND LAYER [1-24]/[25-48] switches to select
either MIX buses 1–24 or MIX buses 25–48 as the
MIX buses that you wish to control.
In the SELECTED INPUT CHANNEL block MIX
SEND section, use the MIX SEND LAYER [1-24]/
[25-48] switches to select the MIX buses that you
wish to control.
4. Use the [ON] switches of the MIX SEND section to
turn the signal sent from the currently selected
channel to each MIX bus on or off.
• MIX SEND section
If the send destination MIX bus is a FIX type, this
step is sufficient to send a nominal level from the
currently selected channel.
Hint
If you turn on the [FIXED MIX PAN] switch located
in the STEREO section of the SELECTED INPUT
CHANNEL block, the signal from after the [PAN]
encoder of that channel will be sent to the FIX type
MIX bus. This method is convenient when you want
the pan setting of the [PAN] encoder to be reflected
in the MIX bus as well.
• STEREO section
• Signal flow when the [FIXED MIX PAN] switch is
off
• Signal flow when the [FIXED MIX PAN] switch is
on
MIX SEND LAYER [1-24]
switch
When this switch is on, MIX
buses 1-24 will be controlled.
MIX SEND LAYER [25-48]
switch
When this switch is on, MIX
buses 25–48 will be controlled.
PAIR
PAIR
MIX SEND [ON] switch
[PRE] switch
[LEVEL] encoder
STEREO
[FIXED MIX PAN] switch
MIX1 MIX2 STEREO L STEREO R
……
……
FADER
INPUT CHANNEL
ON
ON
ON
PAN
MIX1 (FIX)
MIX2 (FIX)
MIX1 MIX2 STEREO L STEREO R
……
……
FADER
INPUT CHANNEL
ON
ON
ON
PAN
MIX1 (FIX)
MIX2 (FIX)