User Manual

CS1D Operating Manual (Basic Operation)
64
5. In the screen, drag the knob located at the intersec-
tion of the source MIX channel and the destination
MATRIX bus to adjust the level of the signal sent
from each MIX channel to the MATRIX bus.
The current value is shown in the numerical box
below the knob.
This parameter can be controlled only in the dis-
play.
6. In order to use the meter bridge to check the (pre-
fader) level of the signals sent to the MATRIX
buses, go to the METER section in the MASTER
block of the console, and turn on the METER [PRE]
switch and the METER SELECT [MATRIX 1-24]
switch.
With these settings, the 24 meters at the right side of
the meter bridge will show the pre-fader levels of the
MATRIX channels.
Hint
The detection point (metering point) shown in the
meters can be specified in greater detail. For details
refer to the section “Setting the metering point” in
“Chapter 16. Various settings.”
7. In the MATRIX OUTPUT block, turn on the
MATRIX [ON] switch for the appropriate MATRIX
channel.
8. In the MATRIX OUTPUT block, raise the MATRIX
[LEVEL] encoder of the appropriate MATRIX chan-
nel.
The signal sent from the MIX channel to the
MATRIX bus will be output from the output jack
patched to that MATRIX channel.
9. In order to use the meter bridge to view the (post-
fader) levels of the signals output from the
MATRIX channels, turn off the METER [PRE]
switch in the METER section of the MASTER block
of the console.
MASTER block
METER [PRE]
switch
METER SELECT
[MATRIX 1-24]
switch
PAIR
ON ON
MATRIX OUTPUT block
MATRIX [ON]
switch
MATRIX [LEVEL]
encoder