User Manual

CS1D Operating Manual (Basic Operation)
66
Pairing MIX channels
Adjacent odd-numbered → even-numbered MIX channels can be paired. All parameters except for pan and delay will be
linked for the two paired channels.
[Procedure]
1. In the MIX OUTPUT block, hold down the [SEL]
switch for one of two adjacent odd-numbered →
even-numbered MIX channels, and then press the
other [SEL] switch.
The direction in which the channel parameters are
copied will depend on the order in which the [SEL]
switches are pressed. When you create a pair, the
parameters of the channel you pressed first will be
copied to the channel that you pressed next, and will
subsequently be linked.
For example if you pair MIX 1 and MIX 2, holding
down the MIX 1 [SEL] switch and then the MIX 2
[SEL] switch will cause the state of MIX 1 to be cop-
ied to MIX 2. For details on the parameters that are
copied/linked when paired, refer to “CS1D Reference
Manual (Appendices)” (→p.45).
If you wish to reset the parameters, do so from the
screen.
When MIX channels are paired, the functions of the
controllers on the CS1D console and the parameters
in the display will change as follows.
■ SELECTED INPUT CHANNEL block
If VARI type MIX buses are paired, the left (odd-
numbered) encoder of the MIX SEND section will
function as a [PAN] encoder to set the panning, and
the right (even-numbered) encoder will function as
the [LEVEL] encoder for both MIX buses.
Adjacent odd-numbered → even-numbered MIX
SEND [ON] switches and MIX SEND [PRE]
switches will be linked.
• When VARI type MIX buses are not paired
• When VARI type MIX buses are paired
MIX1 MIX2 STEREO L STEREO R
……
……
FADER
INPUT CHANNEL
ON
ON
ON
PAN
MIX1 (VARI)
LEVEL
MIX2 (VARI)
LEVEL
MIX1 SEND LEVEL MIX2 SEND LEVEL
PAI R
MIX1 MIX2 STEREO L STEREO R
……
……
FADER
INPUT CHANNEL
ON
ON
PAN
PAN
MIX1/2 (VARI)
LEVEL
MIX1/2 SEND PAN MIX1/2 SEND LEVEL
PAI R