User Manual

Chapter 5. Basic operation for output channels
75
Sending a signal from an output channel to an output unit
Here’s how the SELECTED OUTPUT CHANNEL block can be used to send the signal of an output channel from the
output unit that is patched to that channel.
[Procedure]
1. Use the [SEL] switches of the MIX OUTPUT block,
MATRIX OUTPUT block, or STEREO OUTPUT
block to select the output channel that you wish to
control.
Before using the SELECTED OUTPUT CHANNEL
block, you must first select the output channel that
you wish to control (a MIX channel, MATRIX chan-
nel, or L/R of the STEREO A/B channel).
EQUALIZER
DCA
SAFE
CHANNEL SELECT
SELECTED OUTPUT CHANNEL
ON
DEC INC
SHIFT
DCA section
Assign the currently selected channel
to the desired DCA group.
OUTPUT section
Control the output level and on/off
status of the signal sent from the cur-
rently selected channel to the output
unit or STEREO bus/MATRIX bus.
SAFE section
Temporarily exclude the currently
selected select from Scene Recall
operations or Mute Group operations.
CHANNEL SELECT section
Select/view the channel that will be
controlled in the SELECTED OUT-
PUT CHANNEL block.
PAIR
ON
MIX OUTPUT block
[SEL] switch
PAIR
ON
MATRIX OUTPUT block
[SEL] switch