User Manual

CS1D Operating Manual (Basic Operation)
82
[Procedure]
1. Press a [SEL] switch in the MIX OUTPUT block,
MATRIX OUTPUT block, or STEREO OUTPUT
block to select the output channel that you wish to
control.
2. In the LCD FUNCTION ACCESS block, press the
OUTPUT [COMP] switch several times to access
the following COMP PRM screen.
In the COMP PRM screen you can make compressor
settings for the currently selected output channel.
• COMP PRM screen
3. Click the OUTPUT COMP LIBRARY button in the
upper right of the screen.
The following OUTPUT COMP LIBRARY window
will appear. In this window you can store (save) out-
put channel compressor settings in the library, or
recall (load) existing data from the library.
• OUTPUT COMP LIBRARY popup window
4. From the library list, select data that uses the
desired type.
When you click a line in the library list it will be
highlighted, and the compressor type and parameter
settings used by that data will be displayed in the edit
section.
Hint
Numbers 01–09 are displayed as “READ ONLY,” and
contain read-only preset data. Initially, you may wish
to recall whichever of these presets is closest to the
settings you intend, and then modify the parameters
as necessary.
5. Click the RECALL button located at the lower left
of the library list.
The data you selected in step 4 will be recalled to the
output channel that you selected in step 1.
The OUTPUT COMP LIBRARY popup window will
close, and you will return to the previous COMP
PRM screen.
Hint
If a STEREO A/B channel or one of a pair of MIX/
MATRIX channels is selected, the same data will be
loaded into both channels.
The COMP PRM screen also lets you select the key-
in signal (the reference signal that controls the com-
pressor), and to switch between LPF and HPF to fil-
ter the input signal of the compressor. For details
refer to “CS1D Reference Manual (Software)”
(→p.93).
LCD FUNCTION ACCESS
block
OUTPUT [COMP] block
Library list
This is a list of the output compressor data that has
been stored in memory. The currently highlighted line is
selected for operations.
Edit section
This area shows the settings of
the output compressor data that
is currently selected in the library
list.
These buttons are used for
Store and Recall opera-
tions.