User Manual

Chapter 10. Monitor
111
Controls and functions of the MONITOR A/MONITOR B sections
The controls and functions of the MONITOR A/MONITOR B sections are explained below.
■ MONITOR A section ■ MONITOR B section
Using the MONITOR A section to monitor a signal
Here’s how to use the MONITOR A section to monitor the desired source.
[Procedure]
1. Make sure that your monitor system is connected
to MONITOR OUT jacks A located on the rear
panel of the CS1D. Alternatively, connect a set of
headphones to the MONITOR A headphone jack
located on the top panel or front panel of the CS1D.
Do not use the top panel PHONES MONITOR jack
simultaneously with the front panel MONITOR
headphone jack. Doing so may cause the CS1D to
malfunction due to excessive current.
When the PM1D system is in the initial state, the
settings of the MONITOR A section will be over-
ridden if the [CUE] switch of even one input chan-
nel, output channel, or DCA group is on, and the
cue signal will be output from MONITOR OUT
jacks A. The CUE ACTIVE LED (located in the
MASTER block CUE section) will light if there are
any currently active [CUE] switches.
DELAY
SOURCE
MONITOR A SOURCE [2TR IN 1]/
[2TR IN 2]/[ST A]/[ST B]/[DEFINE]
switches and LEDs
Select the monitor source for the
MONITOR A output. The switch
LED for the currently selected
source will light. (Only one source at
a time can be selected.)
MONITOR A DELAY [TIME]
encoder and [VALUE] indicator
MONITOR A DELAY [ON] switch
and LED
Control the delay built into the MONI-
TOR A output.
MONITOR A [LEVEL] volume
This analog volume controls the
output level of MONITOR A.
MONITOR A [L MONO]/[R MONO]
switches and LEDs
Switch the MONITOR A output
between stereo and monaural.
MONITOR A [ON] switch and LED
Turn the MONITOR A output on/off.
MONITOR A PHONES [LEVEL]
volume
This analog volume controls the
output level of the PHONES MON-
ITOR A jack.
SOURCE
MONITOR B SOURCE [2TR IN 1]/
[2TR IN 2]/[ST A]/[ST B]/[MONI-
TOR A]/[DEFINE] switches and
LEDs
Select the monitor source for the
MONITOR B output. The switch
LED for the currently selected
source will light. (Only one source
at a time can be selected.)
MONITOR B [LEVEL] volume
This analog volume controls the
output level of MONITOR B.
MONITOR B [ON] switch and LED
Turn the MONITOR B output on/off.
MONITOR B PHONES [LEVEL]
volume
This analog volume controls the
output level of the PHONES MON-
ITOR B jack.