User Manual

Chapter 12. Internal effects
131
Hint
•When the EFFECT 1–EFFECT 8 screens are dis-
played, you can obtain the same result by holding
down the [SHIFT/GRAB] switch located in the
data entry block and pressing the MIX LAYER [1-
24] switch or [25-48] switch.
•The ASSIGN button on/off setting is common to
all of the EFFECT 1–EFFECT 8 screens. If you
switch between EFFECT 1–EFFECT 8 screens
when the ASSIGN button is on, the parameters of
the new screen will be assigned.
3. To return to the previous state, click the ASSIGN
button to turn it off.
The encoder functions will return to their previous
state.
Hint
The encoder functions will also return to their previ-
ous state if you access a screen other than EFFECT 1–
EFFECT 8, or if you press either the MIX LAYER [1-
24] or [25-48] switch.
Recalling effect data from the library
It is not possible to switch the effect type from within the EFFECT function screen. If you wish to change the effect type,
you must recall effect data that uses the desired effect. Here’s how you can recall (load) existing effect data from the effect
library.
Hint
The libraries of the PM1D system are an area of internal memory that stores system settings for later reuse, and are
independent of the scene memories. There are other libraries in addition to the effect library explained here, such as
the patch library and EQ library.
[Procedure]
1. In the LCD FUNCTION ACCESS block, press the
[EFFECT] switch several times to access the desired
screen from EFFECT 1 – EFFECT 8.
• EFFECT 1 screen (EFFECT function)
PAI R PAIR
PAI R
PAI R
PAI R
PAI R
PAI R PAIR
PAI R
MIX
LAYER
PAI R PAIR
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
1 - 24
PAI R
Encoders 1–12
Encoders 13–24
CS1D MIX OUTPUT block
LCD FUNCTION ACCESS
block
[EFFECT] switch